摘要
研究了60Si2Mn弹簧钢半固态电磁搅拌工艺和凝固过程,分析电磁搅拌对60Si2Mn弹簧钢凝固组织的影响规律。结果表明:电磁搅拌可以消除60Si2Mn弹簧钢的凝固组织中发达的柱状枝晶层,随着电磁搅拌的功率的增加,60Si2Mn弹簧钢凝固组织从枝晶或短枝晶向等轴晶转变,随着搅拌时间增加,60Si2Mn弹簧钢凝固组织更为圆整。制备合格的60Si2Mn弹簧钢半固态流变浆料的工艺参数:搅拌功率应不低于8.5 kW,搅拌时间应不少于5 min,连续搅拌终止温度应不高于1 460℃。理论分析认为:在60Si2Mn弹簧钢凝固过程中进行电磁搅拌,引起熔体的强烈流动,使液相区的温度场和溶质含量趋于均匀,晶核数量增加,并减慢了奥氏体的一次臂生长速度,最后发展成细小的等轴晶的凝固组织。
The semisolid electromagnetic stirring technology and solidification process of 60Si2Mn spring steel have been studied in this paper, and the influence of electromagnetic stirring parameters on the solidification microstructures of the 60Si2Mn spring steel has been investigated. Results have shown that electromagnetic stirring can eliminate the thick layer of columnar dendric austenite formed in conventional castings. The higher electromagnetic stirring power and the longer electromagnetic stirring time, th...
出处
《特种铸造及有色合金》
CAS
CSCD
北大核心
2001年第S1期247-250,共4页
Special Casting & Nonferrous Alloys
基金
国家自然科基金重大项目(59995440)
关键词
电磁搅拌
半固态金属
凝固
弹簧钢
Electromagnetic stirring
Semi-solid metal
Solidification
Spring steel
