期刊文献+

围护结构热阻的现场检测和数据处理方法 被引量:8

Field Measurement and Data Processing Method of Envelope's Thermal Resistance
在线阅读 下载PDF
导出
摘要 本文讨论了采用热箱法检测建筑物围护结构的热阻以实现非采暖季进行检测。由于检测面大量广,因此检测方法必须相对简便易行。根据这一原则,提出把在两侧测得的热流值加权平均的方法对由于侧向热流引起的误差加以修正,以实现现场测试基本精度。根据建筑围护结构检测的特定情况,用数值模拟的方法归纳总结出适用于不同保温形式的围护结构加权平均系数,即修正系数。通过对三十多种常见的围护结构形式的修正系数及其相应误差值的分析,表明这种修正方法可以满足围护结构热工性能现场检测的要求。 A hotbox method is devised for field measurements of envelope' s thermal resistance in non-heating seasons. Due to the great quantity of tests to be dealt with in practice, the test and data-processing procedures should be relatively convenient and inexpensive. A weighted average method of the heat fluxes measured on both sides of the wall is brought forward in evaluation of the thermal resistance in consideration of the errors caused by the lateral heat losses in the measurements. Numerical simulations were carried out over 30 enclosure structures to obtain appropriate weighting coefficient for different categories of insulated building enclosures. The result shows that this measurement procedure is simple and effective on rectifying the errors resulting from the lateral heat loss in the tests.
出处 《建筑热能通风空调》 2005年第6期80-84,共5页 Building Energy & Environment
关键词 采暖 热阻 检测 热箱法 误差分析 heating, thermal resistance, measurement, hotbox method, error analysis
  • 相关文献

参考文献5

  • 1(JGJ132—2001)[S].中华人民共和国行业标准:《采暖居住建筑节能检验标准》.[S].,2001..
  • 2(DBJ14-022—2003)[S].山东省工程建设标准:《居住建筑节能设计标准》.[S].,2003..
  • 3潘雷,陈宝明,方肇洪,韩保华,郑宜涛.热箱法现场检测建筑物围护结构热阻的探讨[J].建筑热能通风空调,2005,24(2):74-77. 被引量:5
  • 4ASTM C1363-97, Standard Test Method for Steady-State Thermal Performance of Building Assemblies by Means of a Guarded Hot Box [S]. American Society for Testing and Materials, 1997.
  • 5ANSYS公司.ANSYS热分析指南[Z].,1998,12.1-18.

二级参考文献3

  • 1.采暖居住建筑节能检验标准(JGJ132-2001)[S].北京:中国建筑工业出版社,2001.28-37.
  • 2.居住建筑节能设计标准(山东省工程建设标准)(DBJ14-022-2003)[S].北京:中国建筑工业出版社,2003.12-17.
  • 3ANSYS公司.ANSYS热分析指南[Z].,1998,12.1-18.

共引文献5

同被引文献42

引证文献8

二级引证文献31

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部