期刊文献+

基体表面粗糙度对HVOF喷涂WC-Co粒子变形的影响 被引量:12

Effect of Substrate Surface Roughness on the Splat Formation in the HVOF Spraying of WC-Co
在线阅读 下载PDF
导出
摘要 研究了超音速火焰(HVOF)喷涂WC-Co粒子过程中,基体表面粗糙度对粒子平化变形特征及粒子基体间结合性能的影响.实验结果表明:随基体表面粗糙度增大,粒子铺展过程中受到的阻力增大,圆形或近似圆形的粒子比例减少,不规则形貌粒子的比例增加;同时WC-Co粒子与基体间的物理机械嵌合强度提高;适当延长基体吹砂处理时间可增强粒子与基体间的结合强度. The effect of substrate surface roughness on the splat formation and adhesion between WC-Co splat HVOF (high velocity oxy-fuel) sprayed and steel substrate are studied. The results showed that with the increase of surface roughness the restriction to flattening of splat is enhanced so that the number of spherical to nearly spherical particles became reduced while the ratio of splat with complex morphologies increased. Furthermore, the physical contact and adhesion between the WC-Co splat and substrate got better as a result of increased surface roughness. Suitable duration of grit blasting can improve the bonding strength.
出处 《北京理工大学学报》 EI CAS CSCD 北大核心 2006年第4期373-376,共4页 Transactions of Beijing Institute of Technology
基金 国家部委预研项目(20050023)
关键词 超音速火焰 WC-CO 表面粗糙度 平化变形 high velocity oxy-fuel WC-Co surface roughness flattening formation
  • 相关文献

参考文献5

二级参考文献8

  • 1[1]Lugscheider E, Jokiel P. Characterization of particle reinforced nickel hard alloys produced by thermal spraying. Proc. 5th NTSC'93, Anaherm, USA, 1993,411~416
  • 2[2]Knotek O, Lugscheider E, Jokiel P. et al. Chromium coatings by HVOF thermal spraying: simulation and practical results. Proc. 7th NTSC'94, Boston, USA,1994, 179~184
  • 3[3]Marple B R, Voyer J, Simard S. Tungsten carbidebased coatings as alternatives to electrodepostited hard chromium. Proc. UTSC'99, Ed. E. Lugscheider and P.A. Kammer, Dusseldorf, 1999, 122~127
  • 4[4]Gavrilenko T P, Nikolaev Y A, Ulianitsky V Y. D-Gu "OB" detonation spraying. Proc. 14th ITSC'95, Kobe.Japan, 1995, 425~429
  • 5[5]Arsenault B, Legoux J-G, Hawthorne H. Slurry erosion of high velocity oxy-fuel thermal sprayed coatings. Thermal Spray: A United Forum for Scientific and Technology Advances, Ed. C.C.Bemdt.Published by ASM International. Materials Park, Ohio.1997, 97~106
  • 6[6]tasim Z, BankarV, Rimlinger C. High velocity oxy-fuel thermal sprayed coatings as alternates to WC-12Co coatings and chromium plating. Thermal Spray: A United Forum for Scientific and Technology Advances, Ed. C.CBerndt, Published by ASM International, Materials Park, Ohio, 1997. 901~908
  • 7[7]LiC-J, A Ohmori, Y Harada. Formation if amorphous phase in thermally sprayed WC-Co. J Thermal spray technology, 1996,5(1):69~73
  • 8[9]Kuroda S, Tashiro Y, Yumoto H, et al. Peening action and residual stresses in HVOF thermal spraying of 316L stainless steel. Proc. ITSC'98,Nic 1998:569-574

共引文献24

同被引文献139

引证文献12

二级引证文献69

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部