期刊文献+

无烟煤的燃尽特性分析 被引量:9

ANALYSIS OF BURNOUT BEHAVIOR FOR ANTHRACITIC COAL
在线阅读 下载PDF
导出
摘要 空气气氛下热重试验表明,无论在哪种升温速率下,无烟煤的起始着火温度比烟煤约高220℃,燃尽温度比烟煤约高70℃,无烟煤的燃烧时间要大于烟煤。反应动力学模型得到的活化能测试结果表明,无烟煤的活化能比烟煤大30kJ/mol左右。增加炉内换热和延长停留时间,有利于缩短燃煤颗粒的预热时间以及燃烧时间,从而促进无烟煤的燃尽。 Study on thermogravimetric test in the atmosphere of air shows that the burning time of anthractic coal is longer than that of bituminous coal no matter under what kind of the heating rate. The ignition temperature of anthracitic coal is about 200 ℃ higher than that of bituminous coal, the burnout temperature of anthracitic coal is about 70 ℃ higher than that of bituminous coal. The activation energy test results obtained from model of reaction kinetics show that the activation energy of anthracitic coal is about 30 kJ/ mol higher than that of bituminous coal. Increasing heat transfer and extending residence time in the furnace is helpful to shorten preheating time and combustion time of the fuel coal particles, thereby promoting the anthracitic coal to burnout.
机构地区 浙江大学
出处 《热力发电》 CAS 北大核心 2008年第1期13-16,共4页 Thermal Power Generation
关键词 无烟煤 燃尽特性 热重试验 循环流化床 anthracitic coal burnout behavior thermogravimetric test circulating fluidized bed
  • 相关文献

参考文献4

二级参考文献36

  • 1郑洽余,刘信刚,金燕.循环流化床锅炉燃烧室内焦炭粒子燃烧特性的研究[J].工程热物理学报,1995,16(1):106-110. 被引量:17
  • 2王智微.生物质燃料循环流化床的模型化设计(硕士学位论文)[M].清华大学热能工程系,1999..
  • 3[1]MOE T A, MANN M D, HENDERSON A K,et al. Pilot scale CFBC systems: A valuable tool for design and permitting[A]. In : Avidan A A, ed. Proc 4th Int Conf CFB[C]. USA:Pennsylvania, ASME Press, 1993: 116-122.
  • 4[2]GLICKSMAN L R, HYRE M, WESTPHALEN D. Verification of scaling relations for circulating fluidized beds[A]. In: Rubow L N, Commonwealth G, eds. Proc 4th Int Conf CFB[C].USA: San Diego, ASME Press, 1993: 69-70.
  • 5[3]HORIO M. Hydrodynamics of circulating fluidization: present status and research needs[A]. In: Basu P, Large J F, eds. Proc 1st Int Conf CFB[C].Oxford: Pergamon Press, 1991:3-14.
  • 6[4]DIET P W. Collection efficiency of cyclone separators[J]. AIChE, 1981,27(6):125-176.
  • 7[6]BURSI J M, LAFANECHERE L, JESTIN L. Basic design studies for a 600 MW FBC boiler (270 b, 2×600 ℃)[A]. In:Robert B R, ed. Proc of the 15th Int Conf CFB[C], Georgia:Savannah, 1999:16-19.
  • 8[7]ZHANG JIANSHENG, LU JUNFU, YUE GUANGXI, et al. Inverstigation on the circulating fluidized bed boiler Design[A]. Proc of CCC on Boiler Technology[C],Beijing:2002:34-37.
  • 9[8]KEFER V. Critical heat flux (CHF)and post-CHF heat transfer in horizontal and inclined evaporator tubes[J].Int J Multiphase Flow, 1989, 15(3):385-392.
  • 10[9]SKOWYRA R S, CZARNECKI T S, SUN C Y,et al. Design of a supercritical sliding pressure circulating bed boiler with vertical water walls[A]. In: Rubow L N ed. Proc 13th Int Conf on FBC[C], New York: ASME Press,1995:17-25.

共引文献77

同被引文献93

引证文献9

二级引证文献20

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部