期刊文献+

富含纳米孔活性炭的制备、表征及其吸附性能研究 被引量:3

Preparation,Characterization and Adsorption Performance of High Nanometer Pore Activated Carbon
在线阅读 下载PDF
导出
摘要 以玉米秸秆皮为原材料,在无惰性气体氛围下,以ZnCl2为活化剂制备活性炭.以亚甲基蓝为探针分子,通过正交实验获得最优活性炭的制备工艺.通过扫描电镜对所制最优活性炭的表面形貌进行研究,运用氮气吸附-脱附实验对其比表面积和孔容积进行检测,并考察了吸附时间、吸附温度对其吸附亚甲基蓝性能的影响.扫描电镜观测到自制活性炭表面具有大量纳米孔,氮气吸附-脱附实验结果表明,自制活性炭平均孔径为1.98 nm,比表面积达到934 m2/g,孔结构中以微孔为主.自制活性炭在60 min左右可以达到吸附平衡,并且吸附效果随温度升高变化不大,吸附效果明显优于市售活性炭. Activated carbon was prepared from corn stalks by activation of zinc chloride without N2.Using methylene blue as probe molecules,the optimum preparation conditions were obtained by orthogonal experiment.Scanning electron microscope (SEM) and N2 adsorption-desorption were used to characterize the surface morphology and pore structure,the effects of time and temperatme on adsorption of methylene blue were also investigated.SEM results showed that the homemade activated carbon had abundant nanopore structures.The BET results showed that the main pore type of homemade activated carbon was micropore and its average pore width was 1.98 nm,the BET surface area reached 934 m2/g.The adsorption equilibrium time of homemade activated carbon was 60 min and its adsorption ability was less affected by temperature.Homemade activated carbon's adsorption capacity was significantly better than the commercially available activated carbon.
出处 《郑州大学学报(理学版)》 CAS 北大核心 2014年第2期80-84,共5页 Journal of Zhengzhou University:Natural Science Edition
基金 河南省教育厅科学技术研究重点项目指导计划基金资助项目 编号12B430018 河南省重点学科环境科学基金资助项目 编号2012186 平顶山学院青年科研基金资助项目 编号20120014
关键词 玉米秸秆皮 活性炭 氯化锌 扫描电镜 氮气吸附-脱附 corn stalk activated carbon ZnCl2 SEM N2 adsorption-desorption
  • 相关文献

参考文献16

  • 1Kannan N, Rengasamy G. Comparison of cadmium ion adsorption on various activated carbons [ J . Water, Air and Soil Pollu- tion, 2005, 163(1/2/3/4) : 185 -201.
  • 2Lyubchik S B, Perepichka I I, Galushko O L, et al. Optimization of the conditions for the Cr( Ill ) adsorption on activated car- bon[J]. Adsorption, 2005, 11(5/6): 581-593.
  • 3Ngernyen Y, Tangsathitkulchai C, Tangsathitkulchai M. Porous properties of activated carbon produced from eucalyptus and wattle wood by carbon dioxide activationl J]. Korean Journal of Chemical Engineering, 2006, 23 (6) : 1046 -1054.
  • 4魏娜,赵乃勤,贾威.活性炭的制备及应用新进展[J].材料科学与工程学报,2003,21(5):777-780. 被引量:74
  • 5王秀芳,张会平,肖新颜,陈焕钦.高比表面积活性炭研制进展[J].功能材料,2005,36(7):975-977. 被引量:49
  • 6Aroua M K, Leong S P P, Teo L Y, et al. Real-time determination of kinetics of adsorption lead( U ) onto palm shell-based ac- tivated carbon using ion selective electrode[ J ]. Bioresource Technology, 2008, 99 (13) : 5786 -5792.
  • 7李坤权,郑正,蒋剑春,张继彪.铅在棉秆基活性炭上的吸附动力学与热力学[J].环境科学,2010,31(5):1402-1408. 被引量:39
  • 8Kumar P S, Ramalingam S, Sathishkumar K. Removal of methylene blue dye from aqueous solution by activated carbon prepared from cashew nut shell as a new low-cost adsorbent[ J ]. Korean Journal of Chemical Engineering, 2011, 28( 1 ) : 149 -155.
  • 9杨性坤,栗印环.利用花生壳制备活性炭的工艺研究[J].信阳师范学院学报(自然科学版),2001,14(2):226-227. 被引量:20
  • 10李云雁,胡传荣.实验设计与数据处理[M].2版.上海:化学工业出版社,2008:124-159.

二级参考文献163

共引文献267

同被引文献43

  • 1黄伟,孙盛凯,李玉杰,杨爱军,贾艳秋.硝酸改性处理对活性炭性能的影响[J].生物质化学工程,2006,40(6):17-21. 被引量:29
  • 2胡翔,李进,皮运正,王建龙.臭氧氧化产物甲醛的产生机理研究[J].环境科学学报,2007,27(4):643-647. 被引量:9
  • 3MAZZOTI'A E, MALITESTA C, DIAZ-.LVAREZ M, et al.Electrosynthesis of molecularly imprinted polypyrrole for the antibiotic levofloxacin [ J ]. Thin Solid Films, 2012,520(6) :1 938-1 943.
  • 4TONELLI D, BALLARIN B, GUADAGNINI L, et al. A novel potentiometric sensor for L-ascorbic acid based on molecularly imprinted polypyrrole [ J ].Electrochimica Acta,2011,56(20) :7 149-7 154.
  • 5BAGGIANI C, BARAVALLE P, GIOVANNOLI C, et al. Binding behaviour of molecularly imprinted polymers prepared by a hierarchical approach in mesoporous sili- ca beads of varying porosity [ J ] .Journal of Chromatog- raphy A,2011,1218(14) : 1 828-1 834.
  • 6LV Y Q, TAN T W, SYEC F. Molecular imprinting of proteins in polymers attached to the surface of nanoma- terials for selective recognition of biomacromolecules [J]. Biotechnology Advances, 2013, 31 (8) : 1 172- 1 186.
  • 7ZHAO K,CHEN T,LIN B,et al.Adsorption and recogni- tion of protein molecular imprinted calcium alginate/ polyacrylamide hydrogel film with good regeneration performance and high toughness [ J ]. Reactive and Functional Polymers, 2015,87: 7-14.
  • 8ZHANG W, QIN L, CHEN R R, et al. Protein imprinted polymer using acryloyL-[3-cycledextrin and acrylamide as monomers[ J ]. Applied Surface Science, 2010, 256 (9) :3 000-3 005.
  • 9GarcLl A, a-Calz6n, M Dlaz-Garcfa. Characterization of binding sites in molecularly imprinted polymers [ J ]. Sensors and Actuators B: Chemical, 2007, 123 ( 2 ) : 1 180-1 194.
  • 10ZHU X F,CAO Q E,DING Z T,et.al.Preparation and recognition mechanism of gallie acid imprinted polymer [ J] .Helvetica Chimica Acta,2008,91 : 1-10.

引证文献3

二级引证文献9

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部