摘要
研究某铜阳极泥氧压酸浸工艺条件，考察硫酸初始浓度、温度、时间、液固比、压力等对金属浸出的影响。结果表明，当控制浸出硫酸初始浓度130～150g／L、温度155～165℃、时间6～8h、液固比5：1、压力1．0～1．5MPa时，酸浸渣率为55％～60％，碲浸出率为85％～90％，镍、铜浸出率均在99％以上。
Oxygen pressure acid leaching process for copper anode slime was studied. The effects of initial concentration of sulfuric acid, leaching temperature and time, ratio of liquid to solid （L/S）, and pressure on leaching were investigated. The results show that leaching slag rate is 55%-60%, tellurium leaching rate is 85%-90%, and leaching rate of nickel and copper is 99% above under the optimum conditions including initial concentration of sulfuric acid of 130-150 g/L, temperature of 155-165 ℃, time of 6-8 h, L/S=5 ： 1, and leaching pressure of 1.0-1.5 MPa.
出处
《有色金属（冶炼部分）》
CAS
北大核心
2014年第7期14-16,21,共4页
Nonferrous Metals（Extractive Metallurgy)
基金
金川集团股份有限公司"十一五"
"十二五"重点建设项目(2121010)
关键词
铜阳极泥
氧压酸浸
碲
硒
浸出率
copper anode slime
oxygen pressure acid leaching
tellurium
selenium
leaching rate
