期刊文献+

应用于新能源发电的有源钳位隔离型Boost变换器 被引量:1

Active-clamp isolated boost converter applied in renewable energy generation
在线阅读 下载PDF
导出
摘要 传统的隔离型Boost变换器需要使用两个及以上的磁性元件,造成磁性元件数量偏多。文章提出了一种新型有源钳位隔离型Boost变换器,该变换器将变压器、输入电感和谐振电感集成在一个磁性元件中,变换器的开关管数量及增益特性与传统的隔离型全桥Boost变换器相同。通过设置原边有源钳位电路,变换器中所有开关管的电压应力不超过变换器的最高输入电压;设置副边谐振倍压网络,变换器实现了整流二极管的零电流关断。最后在一台500 W的样机进行试验,试验结果验证了该变换器的可行性。 Traditional isolated boost converter requires at least two magnetic components, which results in quite large quantity of magnetic component.Therefore, a novel active-clamp isolated boost converter is proposed, which uses only one magnetic component into which a transformer, an input inductor and a resonant inductor combine.The quantity of power transistor and its converter gain characteristics are the same as traditional isolated full-bridge boost converter.Active-clamp technology is applied in the primary side, which limits the voltage stress of all power transistors within the maximum input voltage of the converter.Resonant voltage doubling network is applied in the secondary side, which realizes zero current switching of rectifying diode.Finally, an experiment is done on a 500W prototype to verify the feasibility of proposed method.
作者 王爱玲
出处 《可再生能源》 CAS 北大核心 2015年第3期375-380,共6页 Renewable Energy Resources
关键词 新能源发电 隔离型Boost变换器 有源钳位 磁性元件 renewable energy generation isolated boost converter active-clamp magnetic component
  • 相关文献

参考文献3

二级参考文献26

  • 1张宪平,林资旭,李亚西,许洪华.LCL滤波的PWM整流器新型控制策略[J].电工技术学报,2007,22(2):74-77. 被引量:45
  • 2Fei Liu ,Yan Zhou, Shanxu Duan ,et al.Parameter Design of a Two-current-loop Controller Used in a Grid-con- nected Inverter System with LCL Fiher[J].IEEE Trans. on Industrial Electronics, 2009,56 ( 11 ) : 4483-4491.
  • 3Manisa P,Michael W,Saifur R.Implications of on-site distributed generation for commercial/industrial facilities[J].IEEE Transactions on Power Systems,2005,20(1):206-212.
  • 4Yuan B,Yang X,Li D,et al.A new architecture for high efficiency maximum power point tracking in grid-connected photovoltaic system[C].Proceedings of the IEEE International Power Electronics and Motion Control Conference,2009:2117-2121.
  • 5Blaabjerg F,Chen Z,Kjaer S B.Power electronics as efficient interface in dispersed power generation systems[J],IEEE Transactions on Power Electronics,2004,19(5):1184-1194.
  • 6Li Q,Wolfs P.A review of the single phase photovoltaic module integrated converter topologies with three different DC link configurations[J].IEEE Transactions on Power Electronics,2008,23(3):1320-1333.
  • 7Carrasco J M,Franquelo L G,Bialasiewicz J T.Power-electronic systems for the grid integration of renewable energy sources:A survey[J].IEEE Transactions on Industrial Electronics,2006,53(4):1002-1016.
  • 8Kjaer S B,Pedersen J K,Blaabjerg F.A review of single-phase grid-connected inverters for photovoltaic modules[J].IEEE Transactions on Industry Application,2005,41(5):1292-1306.
  • 9Xue Y S,Chang L C,Kjaer S B,et al.Topologies of single-phase inverters for small distributed power generation:An overview[J].IEEE Transactions on Power Electronics,2004,19(5):1305-1314.
  • 10Kjaer S B,Pedersen J K,Blaabjerg F.Power inverter topologies for photovoltaic modules-A review[C].Proceedings of the IEEE Industry Applications Conference,2002,2:782-788.

共引文献29

同被引文献4

引证文献1

二级引证文献4

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部