期刊文献+

高效液相色谱法测定复方丹参片与滴丸中7种活性成分含量 被引量:9

Determination of Seven Active Components Compared with Fufang Danshen Tablets and Dripping Pills by HPLC
在线阅读 下载PDF
导出
摘要 目的建立高效液相色谱(HPLC)法同时测定复方丹参片和复方丹参滴丸中7种活性成分的含量。方法采用Zorbax XDB-C18色谱柱,以乙腈-0.1%磷酸溶液为流动相,梯度洗脱,柱温30℃,流速1 m L·min^-1,检测波长为203,270和281 nm。结果 7种成分峰面积与浓度的线性关系良好;加样回收率在95.1%~100.4%;滴丸样品中丹参酮ⅡA未能检出。结论建立了同时测定两类复方丹参制剂中丹参素、原儿茶醛、三七皂苷R1、人参皂苷Rg1、丹酚酸B、人参皂苷Rb1和丹参酮ⅡA含量的方法,精密度高,重复性好,可用于两类复方丹参制剂的质量控制;复方丹参片中丹参酮ⅡA含量明显高于滴丸。 Objective To establish a HPLC method for simultaneous determination of seven active components in Fufang Danshen tablets and Fufang Danshen dripping pills. Methods These seven compounds were analyzed simultaneously with a Zorbax C18column by gradient elution using acetonitrile-0.1% phosphoric acid solution as mobile phase, the flow rate was 1 mL · min^-1 and the detection wavelength was set at 203, 270 and 281 nm, respectively. Results All the seven components showed good linear relation between peak area and concentration of the test, and the average recoveries were between 95.1%- 100.4%.Tanshinone Ⅱ A was not detected in samples of dropping pills. Conclusion The HPLC method to determine the components including tanshinone II A, salvianolic acid B, propanoid acid, protocatechuic aldehyde, notoginsenoside R1, ginsenoside Rg1 and ginsenoside Rb1 of the two different Danshen preparations has been established, and it has the advantages of simplicity, high precision, good repeatability, and can be used for the quality control of two kinds of Fufang Danshen preparations.The content of tanshinone Ⅱ A in Fufang Danshen tablet was distinctly higher than that of dropping pills.
出处 《医药导报》 CAS 2015年第8期1067-1071,共5页 Herald of Medicine
基金 唐山市2013年科学技术研究与发展计划基金资助项目(13130298z) 2012年河北联合大学科学研究基金资助项目(z201242)
关键词 丹参片 复方 丹参滴丸 复方 活性成分 色谱法 高效液相 Fufang Danshen tablets Fufang Danshen dripping pills Active components Chromatography, high performance liquid
  • 相关文献

参考文献15

二级参考文献107

共引文献158

同被引文献83

引证文献9

二级引证文献40

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部