摘要
The present study focuses on source rock evaluation of the Sargelu Formation by using core chips of rocks collected from well Atrush-2, Duhok, Kurdistan Region-Iraq. The Rock-Eval pyrolysis and vitrinite reflectance were executed. Subsequently, the selected parameters were used for source rock evaluation and 1-D Basin Modelling calibration. The upper part of the formation mainly comprises argillaceous limestone with low content of organic matter (0.64% - 1% TOC). By contrast, the lower part is dominated with shale interval and contains high amounts of TOC values (>4% for 1272 - 1278 m) reveling good to very good quality source rock. Accordingly, good to very good hydrocarbon generation potential is suggested for this formation. Organic matter of the Sargelu Formation contains type II and mixed-type II-III kerogen. The values of Tmax and vitrinite reflectance (Ro%) demonstrate that the formation is thermally mature and in the oil zone. In order to construct a thermal history of the formation and determine the timing of hydrocarbon maturation and generation, the 1-D basin modelling PetroMod 2019.1 was used in this study. Based on the 1-D Basin modelling simulation and its outputs, about 3500 m of overburden have been eroded at the study area. The present-day heat flow was found to be 30 mW/m2. The organic matter of Sargelu Formation entered the early oil zone in 64 Ma and reached the main oil zone ca. 5 Ma. The formation is still in the main oil zone at present-day. In well Atrush-2, the highest rate of oil generation for the Sargelu Formation was in the 8.5 Ma, the onset of oil expulsion from Sargelu Formation was in 50 Ma and the expulsion mass has been reached 0.5 Mtons at present-day.
The present study focuses on source rock evaluation of the Sargelu Formation by using core chips of rocks collected from well Atrush-2, Duhok, Kurdistan Region-Iraq. The Rock-Eval pyrolysis and vitrinite reflectance were executed. Subsequently, the selected parameters were used for source rock evaluation and 1-D Basin Modelling calibration. The upper part of the formation mainly comprises argillaceous limestone with low content of organic matter (0.64% - 1% TOC). By contrast, the lower part is dominated with shale interval and contains high amounts of TOC values (>4% for 1272 - 1278 m) reveling good to very good quality source rock. Accordingly, good to very good hydrocarbon generation potential is suggested for this formation. Organic matter of the Sargelu Formation contains type II and mixed-type II-III kerogen. The values of Tmax and vitrinite reflectance (Ro%) demonstrate that the formation is thermally mature and in the oil zone. In order to construct a thermal history of the formation and determine the timing of hydrocarbon maturation and generation, the 1-D basin modelling PetroMod 2019.1 was used in this study. Based on the 1-D Basin modelling simulation and its outputs, about 3500 m of overburden have been eroded at the study area. The present-day heat flow was found to be 30 mW/m2. The organic matter of Sargelu Formation entered the early oil zone in 64 Ma and reached the main oil zone ca. 5 Ma. The formation is still in the main oil zone at present-day. In well Atrush-2, the highest rate of oil generation for the Sargelu Formation was in the 8.5 Ma, the onset of oil expulsion from Sargelu Formation was in 50 Ma and the expulsion mass has been reached 0.5 Mtons at present-day.
作者
Revan Akram
Ayad N. F. Edilbi
Wrya J. Mamaseni
Govand H. Sherwani
Nadhir Al-Ansari
Revan Akram;Ayad N. F. Edilbi;Wrya J. Mamaseni;Govand H. Sherwani;Nadhir Al-Ansari(Department of Petroleum Technology, Erbil Polytechnic University, Kurdistan Region, Iraq;Department of Petroleum Geosciences, Faculty of Science, Soran University, Kurdistan Region, Iraq;Department of Geology, Salahaddin University, Erbil, Kurdistan Region, Iraq;Department of Civil Engineering, Cihan University-Erbil, Erbil, Kurdistan Region, Iraq;Lulea University of Technology, Lulea, Sweden)
