Frequency deviation can be used as an indicator of imbalance between supply and demand. When generation is insufficient, it can cause frequency decline in a power system operation. Implementing under frequency load sh...Frequency deviation can be used as an indicator of imbalance between supply and demand. When generation is insufficient, it can cause frequency decline in a power system operation. Implementing under frequency load shedding (UFLS) is one of the common methods to overcome this problem. This paper proposes a novel approach for adaptive load shedding. The concept is an extension of shared and targeted load shedding using reserve margin. The optimal system configuration is then selected from those candidates to fulfill operational objectives. Operational constraints related to system parameters, threshold frequency, total of load shed and control area including line capacity are considered. An example using four sub-areas connected to an external system shows that the proposed regional coordination as an adaptive UFLS is feasible.展开更多
大规模风电并网系统在受到大功率缺额扰动后,电网会出现频率骤降,而低频减载(Under Frequency Load Shedding,UFLS)控制是防止频率失稳的有效手段。首先,基于含UFLS的改进系统频率响应模型(System Frequency Model,SFR),研究了新型电力...大规模风电并网系统在受到大功率缺额扰动后,电网会出现频率骤降,而低频减载(Under Frequency Load Shedding,UFLS)控制是防止频率失稳的有效手段。首先,基于含UFLS的改进系统频率响应模型(System Frequency Model,SFR),研究了新型电力系统受到大功率扰动下的频率特征,基于经典频率响应模型建立改进的系统频率响应模型,考虑火电、风电联合调频控制策略,并引入UFLS频率控制;然后,根据所建立的系统频率响应模型对大规模风电并网系统参数进行整定,并建立多资源参与调频下的大规模风电并网系统频率特征表达式;最后,通过Matlab/Simulink仿真平台,验证UFLS控制策略参与调频的可行性及UFLS控制参数对频率调制效果的影响。展开更多
Severe disturbances in a power network can cause the system frequency to exceed the safe operating range.As the last defensive line for system emergency control,under frequency load shedding(UFLS)is an important metho...Severe disturbances in a power network can cause the system frequency to exceed the safe operating range.As the last defensive line for system emergency control,under frequency load shedding(UFLS)is an important method for preventing a wide range of frequency excursions.This paper proposes a hierarchical UFLS scheme of“centralized real-time decision-making and decentralized real-time control”for inter-connected systems.The centralized decision-layer of the scheme takes into account the importance of the load based on the equivalent transformation of kinetic energy(KE)and potential energy(PE)in the transient energy function(TEF),while the load PE is used to determine the load shedding amount(LSA)allocation in different loads after faults in real-time.At the same time,the influence of inertia loss is considered in the calculation of unbalanced power,and the decentralized control center is used to implement the one-stage UFLS process to compensate for the unbalanced power.Simulations are carried out on the modified New England 10-generator 39-bus system and 197-bus system in China to verify the performance of the proposed scheme.The results show that,compared with other LSA allocation indicators,the proposed alloca-tion indicators can achieve better fnadir and td.At the same time,compared with other multi-stage UFLS schemes,the proposed scheme can obtain the maximum fnadir with a smaller LSA in scenarios with high renewable energy sources(RES)penetration.展开更多
Under-frequency load shedding （UFLS） is used in the power industry to rescue systems facing extreme disturbances to avoid system collapse. Traditionally, many computations are repeated to seek the proper power syste...Under-frequency load shedding （UFLS） is used in the power industry to rescue systems facing extreme disturbances to avoid system collapse. Traditionally, many computations are repeated to seek the proper power system settings such that the UFLS provides the desired good performance for selected scenarios. An adaptive UFLS method based on the genetic algorithm was developed to automate the finding of optimal parameters to minimize the repetitive trial-error calculations. Simulations demonstrate that the method has better performance than previous schemes and reduces the time and effort of the repetitive simulations.展开更多
The frequency of based on the load pattern the power system varies of the consumers. With continuous increase in the load, the frequency of the system keeps decreasing and may reach its minimum allowable limits. Furth...The frequency of based on the load pattern the power system varies of the consumers. With continuous increase in the load, the frequency of the system keeps decreasing and may reach its minimum allowable limits. Further increase in the load will result in more frequency drop leading to the need of load shedding, if excess generation is not available to cater the need. This paper proposed a methodology in a hybrid thermal-hydro system for finding the required amount of load to be shed for setting the frequency of the system within its minimum allowable limits. The load shedding steps were obtained based on the rate of change of frequency with the increase in the load in both areas. The impact of superconducting magnetic energy storage （SMES） was obtained on load shedding scheme. The comparison of the results was presented on the two-area system.展开更多
The power system is prone to many emergency conditions which may lead to emergency state of operation with decay in the system frequency. The dramatic change in the frequency can result in cascaded failure of the syst...The power system is prone to many emergency conditions which may lead to emergency state of operation with decay in the system frequency. The dramatic change in the frequency can result in cascaded failure of the system. In order to avoid power system collapse, load shedding （LS） schemes are adopted with the optimal amount of load shed. This paper proposed a methodology in a two-area thermal-thermal system for finding the required amount of load to be shed for setting the frequency of the system within minimum allowable limits. The LS steps have been obtained based on the rate of change of frequency with the increase in load in steps. A systematic study has been conducted for three scenarios： the scheme with a conventional integral controller; the scheme with a linear quadratic regulator （LQR）; and the scheme with an LQR and superconducting magnetic energy storage devices （SMES）. A comparison of the results has been presented on the two-area system.展开更多
文摘Frequency deviation can be used as an indicator of imbalance between supply and demand. When generation is insufficient, it can cause frequency decline in a power system operation. Implementing under frequency load shedding (UFLS) is one of the common methods to overcome this problem. This paper proposes a novel approach for adaptive load shedding. The concept is an extension of shared and targeted load shedding using reserve margin. The optimal system configuration is then selected from those candidates to fulfill operational objectives. Operational constraints related to system parameters, threshold frequency, total of load shed and control area including line capacity are considered. An example using four sub-areas connected to an external system shows that the proposed regional coordination as an adaptive UFLS is feasible.
文摘大规模风电并网系统在受到大功率缺额扰动后,电网会出现频率骤降,而低频减载(Under Frequency Load Shedding,UFLS)控制是防止频率失稳的有效手段。首先,基于含UFLS的改进系统频率响应模型(System Frequency Model,SFR),研究了新型电力系统受到大功率扰动下的频率特征,基于经典频率响应模型建立改进的系统频率响应模型,考虑火电、风电联合调频控制策略,并引入UFLS频率控制;然后,根据所建立的系统频率响应模型对大规模风电并网系统参数进行整定,并建立多资源参与调频下的大规模风电并网系统频率特征表达式;最后,通过Matlab/Simulink仿真平台,验证UFLS控制策略参与调频的可行性及UFLS控制参数对频率调制效果的影响。
基金supported in part by the National Key R&D Program of China“Response-driven intelligent enhanced analysis and control for bulk power system stability”under Grant 2021YFB2400800.
文摘Severe disturbances in a power network can cause the system frequency to exceed the safe operating range.As the last defensive line for system emergency control,under frequency load shedding(UFLS)is an important method for preventing a wide range of frequency excursions.This paper proposes a hierarchical UFLS scheme of“centralized real-time decision-making and decentralized real-time control”for inter-connected systems.The centralized decision-layer of the scheme takes into account the importance of the load based on the equivalent transformation of kinetic energy(KE)and potential energy(PE)in the transient energy function(TEF),while the load PE is used to determine the load shedding amount(LSA)allocation in different loads after faults in real-time.At the same time,the influence of inertia loss is considered in the calculation of unbalanced power,and the decentralized control center is used to implement the one-stage UFLS process to compensate for the unbalanced power.Simulations are carried out on the modified New England 10-generator 39-bus system and 197-bus system in China to verify the performance of the proposed scheme.The results show that,compared with other LSA allocation indicators,the proposed alloca-tion indicators can achieve better fnadir and td.At the same time,compared with other multi-stage UFLS schemes,the proposed scheme can obtain the maximum fnadir with a smaller LSA in scenarios with high renewable energy sources(RES)penetration.
文摘Under-frequency load shedding （UFLS） is used in the power industry to rescue systems facing extreme disturbances to avoid system collapse. Traditionally, many computations are repeated to seek the proper power system settings such that the UFLS provides the desired good performance for selected scenarios. An adaptive UFLS method based on the genetic algorithm was developed to automate the finding of optimal parameters to minimize the repetitive trial-error calculations. Simulations demonstrate that the method has better performance than previous schemes and reduces the time and effort of the repetitive simulations.
文摘The frequency of based on the load pattern the power system varies of the consumers. With continuous increase in the load, the frequency of the system keeps decreasing and may reach its minimum allowable limits. Further increase in the load will result in more frequency drop leading to the need of load shedding, if excess generation is not available to cater the need. This paper proposed a methodology in a hybrid thermal-hydro system for finding the required amount of load to be shed for setting the frequency of the system within its minimum allowable limits. The load shedding steps were obtained based on the rate of change of frequency with the increase in the load in both areas. The impact of superconducting magnetic energy storage （SMES） was obtained on load shedding scheme. The comparison of the results was presented on the two-area system.
文摘The power system is prone to many emergency conditions which may lead to emergency state of operation with decay in the system frequency. The dramatic change in the frequency can result in cascaded failure of the system. In order to avoid power system collapse, load shedding （LS） schemes are adopted with the optimal amount of load shed. This paper proposed a methodology in a two-area thermal-thermal system for finding the required amount of load to be shed for setting the frequency of the system within minimum allowable limits. The LS steps have been obtained based on the rate of change of frequency with the increase in load in steps. A systematic study has been conducted for three scenarios： the scheme with a conventional integral controller; the scheme with a linear quadratic regulator （LQR）; and the scheme with an LQR and superconducting magnetic energy storage devices （SMES）. A comparison of the results has been presented on the two-area system.
