The Aronia melanocarpa El oit was used as test material. The microstruc-ture of normal and vitrified shoots and the characteristics of their stomas on leaf surface were compared by paraffin section and leaf epidermis-...The Aronia melanocarpa El oit was used as test material. The microstruc-ture of normal and vitrified shoots and the characteristics of their stomas on leaf surface were compared by paraffin section and leaf epidermis-tearing method. The results showed the palisade tissue of Aronia melanocarpa El oit consists of 2-3 lay-ers of cells. The stomas on lower epidermis cave in, and are smal and dense. There are abundant vessels and sieve tubes in stems. ln contrast, the main veins of vitrified shoots are unobvious, messy and irregular. The boundary between pal-isade tissue and spongy tissue is not obvious. The stomas open circularly and bigly. The stems are swel ing and thick, but the pith parenchyma cells are broken.展开更多
A graded structural material(GSM)with a material transition from TA15 to TC11 was fabricated by wire arc additive manufacturing(WAAM)method.The grain morphology,chemical composition,microstructure and mechanical prope...A graded structural material(GSM)with a material transition from TA15 to TC11 was fabricated by wire arc additive manufacturing(WAAM)method.The grain morphology,chemical composition,microstructure and mechanical properties of the as-deposited GSM were all characterized to investigate their variations along the deposition direction.The results indicate that from TA15 to TC11,the grain size decreases and a transition from columnar grains to equiaxed grains occurs.The content of alloy element alters greatly within a short distance,and the width of the mutation zone is 800μm.Both TA15 and TC11 regions exhibit basketweave microstructure withα-phase andβ-phase.However,during the transition from TA15 to TC11,theα-lath becomes fine,which leads to an increase in microhardness.The tensile test shows that the bonding strength at the interface is higher than the longitudinal strength of TA15,and the lateral elongation at the interface is higher than that of TA15 and TC11.展开更多
Morphology of the spermatozoon of Octopus ocellatus was studied by light, scanning electron, and transmission electron microscopes. Sperm are 600-700 um long, with a large number of granules in diameter about 130 um. ...Morphology of the spermatozoon of Octopus ocellatus was studied by light, scanning electron, and transmission electron microscopes. Sperm are 600-700 um long, with a large number of granules in diameter about 130 um. Each spermatozoon is composed of a head, neck, and tail. The head is made up of an acrosomal complex anterior to the nucleus. The spiral acrosomal complex consists of an electron-lucent vesicle, lacuna, and an electron-dense acrosomal vesicle. Additionally, the spiral acrosomal vesicle has numerous equidistant striations, and is surrounded by many small granules （20 nm diameter）. A long straight nucleus, which is electron-densed, has a deep posterior concavity, the nuclear vacuole. At the terminal end of the nucleus is a sleeve-like structure with a concave posterior nuclear fossa （PNF）. The neck is short connecting the PNF. The basal body is located in the PNF and gives rise to the axoneme. This structure connects the head, neck, and tail. The tail is divided into a middle piece and a principal piece. The middle piece, having a 9＋9＋2 arrangement, is surrounded by a mitochondrial sheath and terminates by an electron-dense fibrous sheath. The principal piece is the longest part of the sperm with coarse fibers tapering posteriorly. The results of this study shall provide some useful information for artificial breeding of this species.展开更多
The crystallization properties and morphology structure of the cationic dyeable polypropylene fibers which were produced by the blending spinning method were studied by making use of X-ray and scanning electron micros...The crystallization properties and morphology structure of the cationic dyeable polypropylene fibers which were produced by the blending spinning method were studied by making use of X-ray and scanning electron microscopy (SEM). It comes to the conclusions that the larger the crystallite size in the fibers is , the better the dyeable properties of the fibers are and there is a little compatibility between the dyeable agent and polypropylene resin. And the dye-uptake of the fibers may be up to 90% because the dyeable agent can uniformly be scattered in polypropylene.展开更多
This work was synthesized CaAl2O4 （calcium aluminate） doped with trivalent praseodymium ions. CaAl2O4 with praseodymium 1.0% and 0.5% were synthesized. The powders of aluminates were characterized by scanning electr...This work was synthesized CaAl2O4 （calcium aluminate） doped with trivalent praseodymium ions. CaAl2O4 with praseodymium 1.0% and 0.5% were synthesized. The powders of aluminates were characterized by scanning electron microscopy and luminescence spectrofluorimetry.CaAl2O4, praseodymium ions, luminescence doped with praseodymium ion that showed less porosity in its grain structure and luminescent transitions that are dependent on the wavelengths of excitation and showing both types of transitions both 5d-4f and 4f-4f.展开更多
文摘The Aronia melanocarpa El oit was used as test material. The microstruc-ture of normal and vitrified shoots and the characteristics of their stomas on leaf surface were compared by paraffin section and leaf epidermis-tearing method. The results showed the palisade tissue of Aronia melanocarpa El oit consists of 2-3 lay-ers of cells. The stomas on lower epidermis cave in, and are smal and dense. There are abundant vessels and sieve tubes in stems. ln contrast, the main veins of vitrified shoots are unobvious, messy and irregular. The boundary between pal-isade tissue and spongy tissue is not obvious. The stomas open circularly and bigly. The stems are swel ing and thick, but the pith parenchyma cells are broken.
基金financial supports from the National Natural Science Foundation of China(Nos.51875041,51875042)。
文摘A graded structural material(GSM)with a material transition from TA15 to TC11 was fabricated by wire arc additive manufacturing(WAAM)method.The grain morphology,chemical composition,microstructure and mechanical properties of the as-deposited GSM were all characterized to investigate their variations along the deposition direction.The results indicate that from TA15 to TC11,the grain size decreases and a transition from columnar grains to equiaxed grains occurs.The content of alloy element alters greatly within a short distance,and the width of the mutation zone is 800μm.Both TA15 and TC11 regions exhibit basketweave microstructure withα-phase andβ-phase.However,during the transition from TA15 to TC11,theα-lath becomes fine,which leads to an increase in microhardness.The tensile test shows that the bonding strength at the interface is higher than the longitudinal strength of TA15,and the lateral elongation at the interface is higher than that of TA15 and TC11.
基金Supported by the Doctor's Fund Item of Shandong Province (No.2006BS06010)National High Technology Research and Development Program of China (863 Program) (No.2007AA09Z433)
文摘Morphology of the spermatozoon of Octopus ocellatus was studied by light, scanning electron, and transmission electron microscopes. Sperm are 600-700 um long, with a large number of granules in diameter about 130 um. Each spermatozoon is composed of a head, neck, and tail. The head is made up of an acrosomal complex anterior to the nucleus. The spiral acrosomal complex consists of an electron-lucent vesicle, lacuna, and an electron-dense acrosomal vesicle. Additionally, the spiral acrosomal vesicle has numerous equidistant striations, and is surrounded by many small granules （20 nm diameter）. A long straight nucleus, which is electron-densed, has a deep posterior concavity, the nuclear vacuole. At the terminal end of the nucleus is a sleeve-like structure with a concave posterior nuclear fossa （PNF）. The neck is short connecting the PNF. The basal body is located in the PNF and gives rise to the axoneme. This structure connects the head, neck, and tail. The tail is divided into a middle piece and a principal piece. The middle piece, having a 9＋9＋2 arrangement, is surrounded by a mitochondrial sheath and terminates by an electron-dense fibrous sheath. The principal piece is the longest part of the sperm with coarse fibers tapering posteriorly. The results of this study shall provide some useful information for artificial breeding of this species.
文摘The crystallization properties and morphology structure of the cationic dyeable polypropylene fibers which were produced by the blending spinning method were studied by making use of X-ray and scanning electron microscopy (SEM). It comes to the conclusions that the larger the crystallite size in the fibers is , the better the dyeable properties of the fibers are and there is a little compatibility between the dyeable agent and polypropylene resin. And the dye-uptake of the fibers may be up to 90% because the dyeable agent can uniformly be scattered in polypropylene.
文摘This work was synthesized CaAl2O4 （calcium aluminate） doped with trivalent praseodymium ions. CaAl2O4 with praseodymium 1.0% and 0.5% were synthesized. The powders of aluminates were characterized by scanning electron microscopy and luminescence spectrofluorimetry.CaAl2O4, praseodymium ions, luminescence doped with praseodymium ion that showed less porosity in its grain structure and luminescent transitions that are dependent on the wavelengths of excitation and showing both types of transitions both 5d-4f and 4f-4f.
