This paper discusses the analysis and design of a very thin slotless permanent magnet （PM） brushless motor whose stator laminations are manufactured from a single strip of steel that is edge wound into a spiral （li...This paper discusses the analysis and design of a very thin slotless permanent magnet （PM） brushless motor whose stator laminations are manufactured from a single strip of steel that is edge wound into a spiral （like a ＂Slinky＂） and then fitted over the windings that are preformed on the outside surface of a non-conducting former. Analytical and finite element analysis （FEA） are used to determine the con- strained optimum dimensions of a motor used to drive a rim driven thruster in which the motor rotor is fit- ted onto the rim of the propeller and the stator is encapsulated in the thin Kort nozzle of the thruster. The paper describes the fabrication of a demonstrator motor and presents experimental results to validate the theoretical calculations. Experimental motor performance results are also reported and compared with those of a slotted motor that fits within the same active radial dimensions as the slotless motor. The slotless motor, which has longer active length and endwindings, and thicker magnets than the slotted motor, was found to be less efficient and more expensive （prototype cost） than the slotted machine.展开更多
The unsteady performance of drag and double reverse propeller podded propulsors in open water was numerically simulated using a computational fluid dynamics （CFD） method. A moving mesh method was used to more realis...The unsteady performance of drag and double reverse propeller podded propulsors in open water was numerically simulated using a computational fluid dynamics （CFD） method. A moving mesh method was used to more realistically simulate propulsor working conditions, and the thrust, torque, and lateral force coefficients of both propulsors were compared and analyzed. Forces acting on different parts of the propulsors along with the flow field distribution of steady and unsteady results at different advance coefficients were compared. Moreover, the change of the lateral force and the difference between the abovementioned two methods were mainly analyzed. It was shown that the thrust and torque results of both methods were similar, with the lateral force results having the highest deviation展开更多
文摘This paper discusses the analysis and design of a very thin slotless permanent magnet （PM） brushless motor whose stator laminations are manufactured from a single strip of steel that is edge wound into a spiral （like a ＂Slinky＂） and then fitted over the windings that are preformed on the outside surface of a non-conducting former. Analytical and finite element analysis （FEA） are used to determine the con- strained optimum dimensions of a motor used to drive a rim driven thruster in which the motor rotor is fit- ted onto the rim of the propeller and the stator is encapsulated in the thin Kort nozzle of the thruster. The paper describes the fabrication of a demonstrator motor and presents experimental results to validate the theoretical calculations. Experimental motor performance results are also reported and compared with those of a slotted motor that fits within the same active radial dimensions as the slotless motor. The slotless motor, which has longer active length and endwindings, and thicker magnets than the slotted motor, was found to be less efficient and more expensive （prototype cost） than the slotted machine.
基金Supported by National Natural Science Foundation of China （41176074, 51209048,51379043,51409063） High tech ship research project of Ministry of industry and technology （G014613002） The support plan for youth backbone teachers of Harbin Engineering University （HEUCFQ1408）
文摘The unsteady performance of drag and double reverse propeller podded propulsors in open water was numerically simulated using a computational fluid dynamics （CFD） method. A moving mesh method was used to more realistically simulate propulsor working conditions, and the thrust, torque, and lateral force coefficients of both propulsors were compared and analyzed. Forces acting on different parts of the propulsors along with the flow field distribution of steady and unsteady results at different advance coefficients were compared. Moreover, the change of the lateral force and the difference between the abovementioned two methods were mainly analyzed. It was shown that the thrust and torque results of both methods were similar, with the lateral force results having the highest deviation
