Many researchers have developed new calculation methods to analyze seismic slope stability problems, but the conventional pseudo-static method is still widely used in engineering design due to its simplicity. Based on...Many researchers have developed new calculation methods to analyze seismic slope stability problems, but the conventional pseudo-static method is still widely used in engineering design due to its simplicity. Based on the Technical Code for Building Slope Engineering（GB 50330-2013） of China and the Guidelines for Evaluating and Mitigating Seismic Hazards in California（SP117）, a comparative study on the pseudo-static method was performed. The results indicate that the largest difference between these two design codes lies in determination of the seismic equivalence reduction factor( f;). The GB 50330-2013 code specifies a single value for f;of 0.25. In SP117, numerous factors,such as magnitude and distance, are considered in determining f;. Two case studies show that the types of slope stability status evaluated by SP117 are in agreement with those evaluated by the seismic time-history stability analysis and Newmark displacement analysis. The factors of safety evaluated by SP117 can be used in practice for safe design. However, the factors of safety evaluated by GB 50330-2013 are risky for slope seismic design.展开更多
Introduces in brief the principle of three kinds pseudo-random code fuzes, viz. the pseudo-random code phase modulation fuze,the pseudo-random code phase modulation and pulse amplitude modulation(PAM) combined fuze,an...Introduces in brief the principle of three kinds pseudo-random code fuzes, viz. the pseudo-random code phase modulation fuze,the pseudo-random code phase modulation and pulse amplitude modulation(PAM) combined fuze,and the pseudo-random code phase modulation and random(pseudo-random) pulse position modulation(PPM) combined fuze. On this basis, their SNR gains in signal processing after band pass filter to the correlation detection, and the overall SNR gains of the whole procedure after correlation detection are deduced in detail. The results show that the latter two kinds of fuzes have the same performances concerning antinoise that are stronger than that of the pseudo-random code phase modulation fuze.展开更多
The frequency bands used in mobile communications are allocated according to the type of application. With the need for more channels, the frequency spectrum has become a scarce natural resource. This study shows the ...The frequency bands used in mobile communications are allocated according to the type of application. With the need for more channels, the frequency spectrum has become a scarce natural resource. This study shows the results of a proposed modulation using a variation of the autocorrelation of pseudo-random codes to carry information. The work also presents the generation of multiple orthogonal axes to increase the bit rate thus improving the channel efficiency.展开更多
A modiΡed pseudo-noise（PN） code regeneration method is proposed to improve the clock tracking accuracy without impairing the code acquisition time performance.Thus,the method can meet the requirement of high accura...A modiΡed pseudo-noise（PN） code regeneration method is proposed to improve the clock tracking accuracy without impairing the code acquisition time performance.Thus,the method can meet the requirement of high accuracy ranging measurements in short time periods demanded by radio-science missions.The tracking error variance is derived by linear analysis.For some existing PN codes,which can be acquired rapidly,the tracking error variance performance of the proposed method is about 2.6 dB better than that of the JPL scheme（originally proposed by Jet Propulsion Laboratory）,and about 1.5 dB better than that of the traditional double loop scheme.展开更多
A method of assigning binary indexes to codevectors in vector quantization (VQ)system, which is called pseudo-Gray coding, is presented in this paper by constructing a kind of Hopfield neural network. Pseudo-Gray codi...A method of assigning binary indexes to codevectors in vector quantization (VQ)system, which is called pseudo-Gray coding, is presented in this paper by constructing a kind of Hopfield neural network. Pseudo-Gray coding belongs to joint source/channel coding, which could provide a redundancy-free error protection scheme for VQ of analog signals when the binary indexes of signal codevectors are used as channel symbols on a discrete memoryless channel. Since pseudo-Gray coding is of combinatorial optimization problems which are NP-complete problems,globally optimal solutions are generally impossible. Thus, a kind of Hopfield neural network is used by constructing suitable energy function to get sub-optimal solutions. This kind of Hop field neural network is easily modified to solve simplified version of pseudo-Gray coding for single bit-error channel model. Simulating experimental results show that the method introduced here could offer good performances.展开更多
A pseudo-random coding side-lobe suppression method based on CLEAN algorithm is introduced.The CLEAN algorithm mainly processes pulse compression results of a pseudo-random coding,and estimates a target＇s distance by...A pseudo-random coding side-lobe suppression method based on CLEAN algorithm is introduced.The CLEAN algorithm mainly processes pulse compression results of a pseudo-random coding,and estimates a target＇s distance by a method named interpolation method,so that we can get an ideal pulse compression result of the target,and then use the adjusted ideal pulse compression side-lobe to cut the actual pulse compression result,so as to achieve the remarkable performance of side-lobe suppression for large targets,and let the adjacent small targets appear.The computer simulations by MATLAB with this method analyze the effect of side-lobe suppression in an ideal or noisy environment.It is proved that this method can effectively solve the problem due to the side-lobe of pseudo-random coding being too high,and can enhance the radar＇s multi-target detection ability.展开更多
The direct sequence ultra-wideband （DS-UWB） is a promising technology for short-range wireless communications. The UWB signal is a stream of very low power density and ultra-short pulses, and the great potential of ...The direct sequence ultra-wideband （DS-UWB） is a promising technology for short-range wireless communications. The UWB signal is a stream of very low power density and ultra-short pulses, and the great potential of DS-UWB depends critically on the success of timing acquisition. A rapid acquisition algorithm for reducing the acquisition time of the coarse pseudo-noise （PN） sequences is proposed. The algorithm utilizes the auxiliary sequence and bisearch strategy based on the threshold comparison criterion. Both theoretical analysis and simulation tests show that with the proposed search strategy and simple operations over the symbol duration at the receiver, the proposed algorithm can considerably reduce the acquisition time even as it maintains the PN sequence acquisition probability in the DS-UWB system over the dense multipath environment.展开更多
GNSS信号的空间信号(SIS)质量直接影响用户的定位、测试和授时(Positioning,Velocity and Timing,PVT)服务精度,但由于授权信号保密等原因,授权信号的伪码序列未知,卫星导航系统授权信号质量评估存在一定的困难性。该文主要分析GPS BII...GNSS信号的空间信号(SIS)质量直接影响用户的定位、测试和授时(Positioning,Velocity and Timing,PVT)服务精度,但由于授权信号保密等原因,授权信号的伪码序列未知,卫星导航系统授权信号质量评估存在一定的困难性。该文主要分析GPS BIIF-5卫星L1频点的相干自适应副载波调制(CASM)信号,利用匹配滤波理论恢复出采集数据中的P(Y)码和M码两个授权信号分量的伪码符号,采用极大似然估计结合信号分布特点准确求解出各信号分量之间的功率分配。重点分析P(Y)码和M码信号相关性能,包含相关曲线、相关损失和S曲线过零点偏差(S-Curve bias),定量地评估了授权信号的空间信号质量。提出完整的基于GPS L1频点授权信号质量评估方法,研究成果可作为其他卫星导航系统授权信号质量评估的参考。展开更多
基金supported by the National Key R&D Program of China(Grant No.2017YFC0404804)the National Natural Science Foundation of China(Grant No.51509019)
文摘Many researchers have developed new calculation methods to analyze seismic slope stability problems, but the conventional pseudo-static method is still widely used in engineering design due to its simplicity. Based on the Technical Code for Building Slope Engineering（GB 50330-2013） of China and the Guidelines for Evaluating and Mitigating Seismic Hazards in California（SP117）, a comparative study on the pseudo-static method was performed. The results indicate that the largest difference between these two design codes lies in determination of the seismic equivalence reduction factor( f;). The GB 50330-2013 code specifies a single value for f;of 0.25. In SP117, numerous factors,such as magnitude and distance, are considered in determining f;. Two case studies show that the types of slope stability status evaluated by SP117 are in agreement with those evaluated by the seismic time-history stability analysis and Newmark displacement analysis. The factors of safety evaluated by SP117 can be used in practice for safe design. However, the factors of safety evaluated by GB 50330-2013 are risky for slope seismic design.
基金Sponsored by National Defence Key Technology Pre-research Program During the Tenth Five-Year Plan Period
文摘Introduces in brief the principle of three kinds pseudo-random code fuzes, viz. the pseudo-random code phase modulation fuze,the pseudo-random code phase modulation and pulse amplitude modulation(PAM) combined fuze,and the pseudo-random code phase modulation and random(pseudo-random) pulse position modulation(PPM) combined fuze. On this basis, their SNR gains in signal processing after band pass filter to the correlation detection, and the overall SNR gains of the whole procedure after correlation detection are deduced in detail. The results show that the latter two kinds of fuzes have the same performances concerning antinoise that are stronger than that of the pseudo-random code phase modulation fuze.
文摘The frequency bands used in mobile communications are allocated according to the type of application. With the need for more channels, the frequency spectrum has become a scarce natural resource. This study shows the results of a proposed modulation using a variation of the autocorrelation of pseudo-random codes to carry information. The work also presents the generation of multiple orthogonal axes to increase the bit rate thus improving the channel efficiency.
基金supported by the National Natural Science Foundation of China (60904090)the Postdoctoral Science Foundation of China(20080431306)the Special Postdoctoral Science Foundation of China (20081458)
文摘A modiΡed pseudo-noise（PN） code regeneration method is proposed to improve the clock tracking accuracy without impairing the code acquisition time performance.Thus,the method can meet the requirement of high accuracy ranging measurements in short time periods demanded by radio-science missions.The tracking error variance is derived by linear analysis.For some existing PN codes,which can be acquired rapidly,the tracking error variance performance of the proposed method is about 2.6 dB better than that of the JPL scheme（originally proposed by Jet Propulsion Laboratory）,and about 1.5 dB better than that of the traditional double loop scheme.
文摘A method of assigning binary indexes to codevectors in vector quantization (VQ)system, which is called pseudo-Gray coding, is presented in this paper by constructing a kind of Hopfield neural network. Pseudo-Gray coding belongs to joint source/channel coding, which could provide a redundancy-free error protection scheme for VQ of analog signals when the binary indexes of signal codevectors are used as channel symbols on a discrete memoryless channel. Since pseudo-Gray coding is of combinatorial optimization problems which are NP-complete problems,globally optimal solutions are generally impossible. Thus, a kind of Hopfield neural network is used by constructing suitable energy function to get sub-optimal solutions. This kind of Hop field neural network is easily modified to solve simplified version of pseudo-Gray coding for single bit-error channel model. Simulating experimental results show that the method introduced here could offer good performances.
文摘A pseudo-random coding side-lobe suppression method based on CLEAN algorithm is introduced.The CLEAN algorithm mainly processes pulse compression results of a pseudo-random coding,and estimates a target＇s distance by a method named interpolation method,so that we can get an ideal pulse compression result of the target,and then use the adjusted ideal pulse compression side-lobe to cut the actual pulse compression result,so as to achieve the remarkable performance of side-lobe suppression for large targets,and let the adjacent small targets appear.The computer simulations by MATLAB with this method analyze the effect of side-lobe suppression in an ideal or noisy environment.It is proved that this method can effectively solve the problem due to the side-lobe of pseudo-random coding being too high,and can enhance the radar＇s multi-target detection ability.
基金supported by the National Natural Science Foundation of China (60572024)the Doctoral Fund of the Ministry of Education of China (20050293003)the National Basic Research Program (2007CB310607)
文摘The direct sequence ultra-wideband （DS-UWB） is a promising technology for short-range wireless communications. The UWB signal is a stream of very low power density and ultra-short pulses, and the great potential of DS-UWB depends critically on the success of timing acquisition. A rapid acquisition algorithm for reducing the acquisition time of the coarse pseudo-noise （PN） sequences is proposed. The algorithm utilizes the auxiliary sequence and bisearch strategy based on the threshold comparison criterion. Both theoretical analysis and simulation tests show that with the proposed search strategy and simple operations over the symbol duration at the receiver, the proposed algorithm can considerably reduce the acquisition time even as it maintains the PN sequence acquisition probability in the DS-UWB system over the dense multipath environment.
